In this article, we’ll cover two methods for performing a factory reset on Whatsminer M50 Series: Whatsminertool and the reset button.
Table of Contents
Reset Miner Settings Using the Utility Whatsminertool
- Select miner(s) ①to reset
- Click [ Remote Ctrl ] ②
- Select ( Restore Factory Settings ) ③
- Click [ Ok ] ④
- In the pop-up window, confirm your intentions by clicking [ Ok ]
Reset Miner Settings Using the Button on the Control Board
A suitable diameter object is required because. the reset button is recessed into the body to prevent accidental pressing.
- Press the button [ Reset ] ①and hold it down for at least 5 seconds.
LED ②will blink and the miner will reboot with default settings.
FAQs
Can You Turn Off ASIC Miner?
There isn’t a hard switch on the miner because it is directly connected to the power source. You only need to pull the power plug (pulling the plug, not the power cable) to disconnect the power.
How Long Do Whatsminer M50S Last?
With a guaranteed higher efficiency and longer running cycle, MicroBT Whatsminer M50S have a lifespan of more than 4 years.
Is MicroBT Whatsminer M50 Profitable?
Whatsminer M50 profitability
