Downlaod the BiXBiT custom firmware for Whatsminer M50 series to overclock Whatsminer, which is designed for all Whatsminer M5x models.
Alternative Whatsminer M5x series firmware is created for all models and enables ASIC upclocking depending on configuration.
- Removes factory restrictions on PSU, voltage and chip frequencies.
- enables power increases of up to 10% on three boards and 40% on two.
- 2.8% development fee.
Installation Manual
- Download BiXBiT firmware for Whatsminer M5x series
Use WhatsMinerTool for the installation
It is necessary to flash the ASIC using the SD-card in the event that the firmware cannot be installed using WhatsMinerTool. For this:
- Check the version of your control board (for Whatsminer M5x these are H6os, H616 control boards)
- Download the utility for reverting your equipment to the service firmware: for H6os boards or H616boards
- the ASIC in preparation for SD card flashing. The detailed process is shown in the video below:
- Once the firmware is installed, open the ASIC’s web panel and go to the Configuration>Miner Configuration>Overclock. Here are the ASIC’s configuration settings.
This section also has the Immersion Cooling option, which has to be checked if you immerse the ASIC into liquid. If there are errors related to the PSU cooler, it is required to flash the PSU using the function in the firmware: Upgrade PSU Firmware under Configuration > Miner Configuration > PSU Firmware.